Link ECU LS Stepper Adapter Harness Map Pin 3: CAN L

Pin 3: CAN L

Please check your connector matches the header in the listed photo and check the notes in italic below before purchasing

CAN Configurable with G4X PC Link – Change LED backlight

800kpa = 4

Note that injector ballast resistors get quite hot at high injector duty cycles

Link ECU LS Stepper Adapter Harness Map Pin 3: CAN LIntended for use with our terminated LS engine harness. Plug and play compatibility with GM LS IAC stepper motors. If you are planning to run a drive by cable configuration on our terminated LS harness you will need this part. This adapter loom terminates to Aux 5,6,7,and 8 via the pre wired stepper adapter connector in the engine harness