Stainless steel air vent 16mm - angled motor Bent elbow enables the hose

Bent elbow enables the hose to be connected at 90°

It is sometimes not possible to install the stern thruster pod at a sufficient depth: ideally

Replacement lip seal set for Vetus water-lubricated inner bearings / stern glands

Maximum number of displays: 2

The ring nut and deck ring are supplied as standard

Stainless steel air vent 16mm - angled motor Bent elbow enables the hoseVetus ST04HS air vent, suitable for 16mm hose. Used to vent fuel, water and waste tanks to allow air to escape when the tank is being filled and for air to enter as the tank is emptied. Angled 90 fitting, manufactured of AISI 316 stainless steel and equipped with a gauze to prevent the ignition of petrol fumes in the vent pipe or the tank. Cut out: 20mm Suitable for wall thickness: 1 10mm